Effortless Guide to Applying Dirt Bike Graphics on Plastics- The Easiest Way!

The easiest way to apply dirt bike graphics on plastics

Are you looking to personalize your dirt bike with some eye-catching graphics? Applying graphics to the plastic parts of your dirt bike can be a fun and rewarding project. However, doing it the right way can be tricky. In this article, we will guide you through the easiest way to apply dirt bike graphics on plastics, ensuring a professional-looking finish every time.

First and foremost, it’s essential to gather the right materials and tools for the job. Here’s a list of what you’ll need:

1. High-quality dirt bike graphics: Ensure they are made of durable, weather-resistant materials.
2. Cleaning solution: Use a degreaser to clean the plastic surface.
3. Microfiber cloth: Use it to wipe down the surface and remove any remaining dirt or grime.
4. Squeegee: A squeegee is used to smooth out the graphics and remove any air bubbles.
5. Scissors or a craft knife: Use these to trim the graphics to size.
6. Hairdryer or heat gun: This will help to apply the graphics and make sure they adhere properly.

Now that you have all the necessary materials, let’s dive into the step-by-step process:

1. Clean the plastic surface: Thoroughly clean the area where you will be applying the graphics. Use a degreaser and a microfiber cloth to ensure the surface is free of any dirt, grease, or other contaminants.

2. Measure and trim the graphics: Lay the graphics flat on a clean, flat surface. Measure the plastic surface and trim the graphics to size using scissors or a craft knife. Make sure to leave a small border around the edges to ensure a clean, seamless look.

3. Position the graphics: Place the trimmed graphics on the plastic surface, ensuring they are properly aligned. Use a credit card or the back of a squeegee to press down the graphics, starting from the center and working your way outwards.

4. Apply heat: Use a hairdryer or heat gun to apply heat to the back of the graphics. This will help the adhesive to activate and adhere to the plastic surface. Work in small sections, moving the heat gun or hairdryer back and forth to ensure even heat distribution.

5. Smooth out the graphics: Once the adhesive is activated, use a squeegee to smooth out the graphics. Start from the center and work your way outwards, pressing firmly to remove any air bubbles and ensure a tight bond.

6. Trim any excess: Once the graphics are fully adhered, use scissors or a craft knife to trim any excess material from the edges.

7. Allow the graphics to cure: Give the graphics ample time to cure and adhere to the plastic surface. This may take anywhere from 24 to 48 hours, depending on the temperature and humidity.

By following these simple steps, you can apply dirt bike graphics on plastics with ease. Remember to take your time and work carefully to achieve the best results. With a little patience and attention to detail, you’ll have a personalized dirt bike that turns heads on and off the track.